Block Insert

The blockinsert command opens a palette of previews of every block in the drawing and places the one you pick. Make blocks with Block Create, or open a DXF file that has them.

Placing a block

  1. Type blockinsert or click Block Insert in the Blocks panel. The palette docks at the left with a preview tile for each block, twelve to a page; the arrows below the tiles turn the page.
  2. Type in Search blocks to narrow the tiles by name.
  3. Set Scale (it must be greater than 0) and Rotation in degrees. Repeat placement is on by default.
  4. Click a block’s tile. The block follows the cursor: click to place it by its base point, or type X,Y for an exact position. Once the cursor is locked to an angle, you can type a length instead.
  5. With Repeat placement on, the block keeps following the cursor for the next copy until you press Escape. With it off, the command ends after one copy.

Good to know

  • To delete a block, click the bin on its tile and confirm. A block that has references in the drawing can’t be deleted: its tile says In use, can’t be deleted.
  • A drawing with no blocks shows This drawing has no blocks in the palette.
  • Escape closes the palette when nothing is being placed. It is one of the docked panels, which show one at a time at the left.

Related: Block Create, Explode, Import