Coordinate Entry
Wherever a command asks for a point — the start of a Line, a corner of a Rectangle, the base point of a Move, or a grip you are dragging — you can type it instead of clicking. Start typing a number and the terminal shows what you type; press Enter or Space to place the point.
Four ways to write a point
| You type | The point is |
|---|---|
100,50 | At X 100, Y 50 |
@100,50 | 100 along X and 50 along Y from the last point |
100<45 | 100 from the origin, at 45° |
@100<45 | 100 from the last point, at 45° |
Angles are in degrees, counterclockwise from the X axis, so @50<90 is 50 straight up and @50<180 is 50 to the left. Either value can be negative.
The last point
@ measures from the last point picked or typed, in any command — the previous command’s last click counts, and so does a grip you just dragged. With no last point yet, @100,50 reads as 100,50. The last point is forgotten when you switch between model space and a layout, and when a drawing is opened.
Rel: relative by default
The Rel toggle in the control bar starts every typed point as relative: as soon as you type the first digit, an @ goes in front of it, so 100,50 becomes @100,50. Press Backspace over the @ to make that one point absolute. With no last point yet, no @ is added. Rel is off by default and is remembered with the other control bar toggles.
Keys while typing
| Key | Effect |
|---|---|
0–9, ., - | Type the number; - only at its start |
@ | Make the point relative, at the start of X |
, or Space | End X and go on to Y |
< | End X as a distance and go on to its angle |
| Enter or Space | Place the point, once Y has a value |
| ← → Home End | Move the caret within the value being typed |
| Backspace | Delete before the caret; at the start of an empty Y, go back to X |
A point that doesn’t read as numbers stays in the terminal for you to correct. Each typed point leaves a line in the terminal history as you typed it — Typed @100<45 — ahead of the command’s own line with where it landed.
Typed points and angle tracking
When the cursor is locked to an angle tracking ray, typing a number gives a distance along that ray rather than an X. Typing @ first starts a full point instead, so @100,50 still works on a locked ray.
Related: Distance Tracking to type a length along a locked direction, and Vector Pins to measure from a pinned point.