Object Snap Settings
The objectsnapsettings command opens one window that holds every control bar setting. Each setting is explained beside the list, with a small drawing. Open it with the gear button in the control bar, or type objectsnapsettings. A setting changed here is the same as switching its button in the bar.
The settings
Where the cursor lands
| Control bar | What it does |
|---|---|
Snap | The cursor jumps to the nearest grid point, so the points you pick land on round coordinates. A snap to an object near the cursor still wins. The grid step follows the zoom. |
TANG | While a line is drawn from a point, bring the cursor near where it would just touch a circle, arc, ellipse or spline and it snaps there. Works in Line, Polyline and other commands, and when dragging the end of a line or polyline. |
Guides while drawing
| Control bar | What it does |
|---|---|
ANGL | When the cursor comes close to one of these angles from the last point, it locks onto that direction, shown as a dashed ray. While it is locked, type a length and press Enter to place the point that far along. |
Pins | Rest the cursor on a snap point for a moment to pin it. A pinned point sends out horizontal and vertical guide lines, and the cursor snaps onto them and to where they cross. |
Dist | Lets the last pinned point act as a start point: when the cursor locks onto an angle from the pin, type a length and press Enter to place the point that far from it. Needs vector pins. |
Typing and selecting
| Control bar | What it does |
|---|---|
Rel | A typed X,Y point is measured from the last point picked, as if it started with @. Backspace removes the @ for a point in the drawing’s own coordinates. With it off, type @ yourself for an offset. |
Lasso | Press and drag on empty space to draw a free-form loop around what you want, instead of a rectangle. What the loop takes in is selected. |
Display
| Control bar | What it does |
|---|---|
Grid | Shows the background grid. Its spacing changes as you zoom. Turning it off doesn’t stop snapping to the grid. |
LWT | Draws lines at their lineweight, so heavier lines look thicker. With it off every line is drawn thin, which can make a dense drawing easier to read. |
ANGL has its own row for the step: pick 10°, 20°, 30°, 45° or 90°, or choose Custom and type any angle from 1° to 180°.
Tangent snap, relative input and the lasso are off by default. Reset to defaults puts every setting back to how it starts.
Related: Vector Pins, Distance Tracking, Grid & Snap, Coordinate Entry